ScanImage 2019 : Z Actuator Calibration in Microns

Can you calibrate the Z actuator so that the user can command it in microns, instead of a voltage/current?


Yes. The Z commands are all done in units of microns. You can see this in the windows reference guide, (Stack Controls).

We generate an electronic signal (in volts) that translates microns to voltage.

The translation-factor is specified in the MDF (machine data file).

That voltage signal is used to tell a controller (another box of equipment) the target position.

That controller drives things in closed loop.

Thus, it will convert the voltage back to microns, and compare that with the measured position of the Z-actuator in order to compute a drive signal to give to the actuator.


Useful ScanImage Links:

  1. Stack Controls
  2. Machine Data File