ScanImage 2018 : Analog Stage Controller Settings


Analog Stage Controller Settings Panel

Command Configuration Settings


Command Scaling Factor (v / um)Enter the conversion factor, in volts per microns, for the command signal to the analog linear stage controller.
Command Volts Offset (v)Enter the offset value, in volts, for the command signal to the analog linear stage controller.
Maximum Voltage Command (v)

Enter the maximum allowable voltage command.

This is an optional limit. If both the Maximum Voltage and the Maximum Position commands are left blank, a the system will use a default limit of +10 volts.

If values were entered for both the Maximum Voltage and the Maximum Position commands, the system will use the smaller value, when converted to voltage units.

Minimum Voltage Command (v)

Enter the minimum allowable position voltage command.

This is an optional limit. If both the Minimum Voltage and the Minimum Position commands are left blank, a the system will use a default limit of -10 volts.

If values were entered for both the Minimum Voltage and the Minimum Position commands, the system will use the larger value, when converted to voltage units.

Maximum Position Command (um)

Enter the maximum position command in microns.

This is an optional limit. If both the Maximum Voltage and the Maximum Position commands are left blank, a the system will use a default limit of +10 volts, converted to micron units.

If values were entered for both the Maximum Voltage and the Maximum Position commands,the system will use the smaller value, when converted to voltage units.

Minimum Position Command (um)

Enter the minimum position command in microns.

This is an optional limit. If both the Minimum Voltage and the Minimum Position commands are left blank, a the system will use a default limit of -10 volts.

If values were entered for both the Minimum Voltage and the Minimum Position commands, the system will use the larger value, when converted to voltage units.

Analog Command Daq

Select the DAQ where the position control signal is wired.

Analog Command Channel ID

Select the Channel where the position control signal is wired.

Sensor Configuration Settings


Sensor Scaling Factor (v / um)

Enter the conversion factor, in volts per microns, for the sensor signal from the analog linear stage controller.

Leave empty for automatic calibration.

Sensor Volts Offset (v)

Enter the offset value, in volts, for the sensor signal from the analog linear stage controller.

Leave empty for automatic calibration

Analog Sensor Daq Name

Select the DAQ where the position sensor signal is wired.

Analog Sensor Channel ID

Select the Channel where the position sensor signal is wired.

 

 

 

 

 

Attachments: