TRIGGERS Panel

Description

Assign and configure External Trigger signals to synchronize image acquisition with experimental events.

To open this dialog, select the menu item from the Main Controls >> Settings Menu >> Triggers...

The terminals available in the External Trigger Configuration depends on the "digitalIODeviceName" variable in the Machine Data File . The following table describes what terminals are available:

Type of digitialIODeviceName	Available Trigger Terminals	Notes
DAQmx Device	PFI1	Usually connected to a PXIe Data Acquisition Card (e.g. NI PXIe-6356 or NI PXIe-6341). These correspond to the `PFI` terminals on the Scan Control DAQ to use for external triggering.
	PFI2
	PFI3
	PFI4
FPGA/RIO Device	DIO0.0	Usually connected to a National Instruments SCB-68A or other terminal block.
	DIO0.1
	DIO0.2
	DIO0.3

External Trigger Configuration

	Assign a role to an external trigger. See Acquisition Triggering for a description of each role. This is the physical terminal to which your trigger signal is attached. Icon Each physical terminal can be connected to one or more trigger functions.
	Configure the input terminal to expect either a rising or falling TTL transition. The edge on which the trigger signal generates the selected trigger function. Icon A trigger function can be assigned to the rising edge and falling edges of a single physical terminal.

External Trigger Test Panel

	Generates an "Acquisition Start" trigger signal.
	Generates an "Acquisition Stop" trigger signal.
	Generates a "Next File Marker" trigger signal.

Icon

The External Trigger Test Panel buttons can only be used if External Triggering is enabled in the Main Controls Window.

Icon

You can use the External Trigger Test Panel to test your scanimage configuration without having to actually generate external hardware test signals.

ScanImage 2016 : Trigger Controls

Description

External Trigger Configuration

External Trigger Test Panel

Attachments: